2021-05-19, 10:44 AM
Hello everyone,
I have an old Autohelm ST2000 (pre-raymarine version, no NMEA, only SeaTalk), that i would like to control from OpenPlotter, to use it with signalk-autopilot. That would be the last step in the current "OpenPloterization" of my boat
I know this topic is partially covered in this thread but i understand most of the information is obsolete after the release of the GPIO app.
That being said, i have serious issues figuring out:
1) The needed hardware to connect my Raspberry Pi4 + Moitessier HAT to ST2000. Especially if I can achieve it without "crafting" any PCB, cause I don't have the skills (I will learn them if no alternative, of course).
2) How to setup gpio app.
Any help will be greatly appreciated, thanks!
I have an old Autohelm ST2000 (pre-raymarine version, no NMEA, only SeaTalk), that i would like to control from OpenPlotter, to use it with signalk-autopilot. That would be the last step in the current "OpenPloterization" of my boat
I know this topic is partially covered in this thread but i understand most of the information is obsolete after the release of the GPIO app.
That being said, i have serious issues figuring out:
1) The needed hardware to connect my Raspberry Pi4 + Moitessier HAT to ST2000. Especially if I can achieve it without "crafting" any PCB, cause I don't have the skills (I will learn them if no alternative, of course).
2) How to setup gpio app.
Any help will be greatly appreciated, thanks!