2023-02-09, 07:13 AM
(This post was last modified: 2023-02-09, 07:18 AM by Rae Simpson.)
I added devices via signal K and they seem to work OK.
BUT - I'm not getting benefit of aliases and OpenPlotter complains on start up.......
Checking serial connections alias...
↳There are serial connections with no alias assigned:
Signal K -> connection ID: GPSPuck | device: /dev/serial/by-id/usb-u-blox_AG_-_www.u-blox.com_u-blox_7_- _GPS_GNSS_Receiver-if00
Signal K -> connection ID: VHF | device: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_AH06ROZO-if00-port0
Serial displays the 2 connections in red but not under devices.
Looking for advise on how to correct this.
Cheers...
Rae
Install is on a 64 bit Raspberry Pi 4, with the latest updates.
BUT - I'm not getting benefit of aliases and OpenPlotter complains on start up.......
Checking serial connections alias...
↳There are serial connections with no alias assigned:
Signal K -> connection ID: GPSPuck | device: /dev/serial/by-id/usb-u-blox_AG_-_www.u-blox.com_u-blox_7_- _GPS_GNSS_Receiver-if00
Signal K -> connection ID: VHF | device: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_AH06ROZO-if00-port0
Serial displays the 2 connections in red but not under devices.
Looking for advise on how to correct this.
Cheers...
Rae
Install is on a 64 bit Raspberry Pi 4, with the latest updates.