This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Quick question about Ais
#1
Hi!
Sorry if this is a stupid question but I need to be sure that I'm doing correct.


My question is: If I have configured a ais dongle in openplotter and then want to receive those signals headless from a remote computer I need to set the configuration in opencpn on the remote computer to:
In
localhost:10109 TCP
Out
localhost:10110 UDP

And then connect to network "openplotter"

Is that correct? I'm using default settings for the network and the raspberry is working as an ap.

//Patrik
Reply
#2
If you are using openplotter as access point, you have to connect your remote computer to that access point and set opencpn on your remote computer to listen to port TCP 10.10.10.1:10109, you do not need an output setting.
Reply
#3
(2017-06-07, 04:58 PM)Sailoog Wrote: If you are using openplotter as access point, you have to connect your remote computer to that access point and set opencpn on your remote computer to listen to port TCP 10.10.10.1:10109, you do not need an output setting.

Thanks!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)