2017-06-29, 10:41 PM
So you only want a connection to 192.168.1.100 over eth0.
change ip in openplotter.conf to 192.168.1.1
Enable access point
Enable bridge to eth0
Apply
reboot
In this mode OpenPlotter acts like a router (dhcp).
When you connect a notebook or pc to the rpi over eth0 or wlan0 its identical it will get an ip in the 192.168.1.xxx Net.
change ip in openplotter.conf to 192.168.1.1
Enable access point
Enable bridge to eth0
Apply
reboot
In this mode OpenPlotter acts like a router (dhcp).
When you connect a notebook or pc to the rpi over eth0 or wlan0 its identical it will get an ip in the 192.168.1.xxx Net.