2017-06-30, 05:29 PM
(This post was last modified: 2017-06-30, 06:16 PM by benjamingotke.)
Ive got the accesspoint back up again. Put in 10.10.10.1, restart and waited for two hours. So i'm back to basic.
Okay i got an update:
Wlan0 is now running accesspoint as normal.
10.10.10.1
netmast 255.255.255.0
Perfect.
Wlan1 unplugged
eth0 share internet.
eth0 on 255.255.255.0
perfect.
plugged eth0 to router with internet and plugged relay to same router.
get to 192.168.1.100 and wow! now i can control my relay.
run sudo arp-scan --interface eth0 --localnet
got printers, computers, relay and everything on the local net.
Unplugged the internet from the router so only Openplotter and relay connected.
ran sudo arp-scan --interface eth0 --localnet
could see the relay - great!
went to browser and tapped 192.168.1.100
but nothing... "This site can't be reached"....
Okay i got an update:
Wlan0 is now running accesspoint as normal.
10.10.10.1
netmast 255.255.255.0
Perfect.
Wlan1 unplugged
eth0 share internet.
eth0 on 255.255.255.0
perfect.
plugged eth0 to router with internet and plugged relay to same router.
get to 192.168.1.100 and wow! now i can control my relay.
run sudo arp-scan --interface eth0 --localnet
got printers, computers, relay and everything on the local net.
Unplugged the internet from the router so only Openplotter and relay connected.
ran sudo arp-scan --interface eth0 --localnet
could see the relay - great!
went to browser and tapped 192.168.1.100
but nothing... "This site can't be reached"....