Hi all,
I configured openplotter 0.8.0 on a rasp PI3.
After that I added openvpn, but if I activate openvpn service the kplex dies with segmentation fault.
I remark that openplotter 0.8.0 works correctly, openvpn stand alone works correctly.
Also using the last version kplex 1.3.2 I see the same behaviour.
The issue seems on udp part input connection.
Davide
I configured openplotter 0.8.0 on a rasp PI3.
After that I added openvpn, but if I activate openvpn service the kplex dies with segmentation fault.
I remark that openplotter 0.8.0 works correctly, openvpn stand alone works correctly.
Also using the last version kplex 1.3.2 I see the same behaviour.
The issue seems on udp part input connection.
Davide
Code:
pi@raspb13:~ $ sudo service openvpn stop
pi@raspb13:~ $ kplex -d9 -f kplex.conf.udp
kplex DEBUG: Using config file kplex.conf.udp
kplex DEBUG: kplex starting, config file kplex.conf.udp
kplex DEBUG: system_input: BINDTODEVICE succeeded on device lo
kplex DEBUG: udp interface system_input listening on 127.0.0.1, port 10110
^Ckplex DEBUG: Cleaning up data for exiting input interface system_input id 10000
kplex DEBUG: Kplex exiting
pi@raspb13:~ $
pi@raspb13:~ $
pi@raspb13:~ $
pi@raspb13:~ $ sudo service openvpn start
pi@raspb13:~ $ sudo service openvpn status
● openvpn.service - OpenVPN service
Loaded: loaded (/lib/systemd/system/openvpn.service; enabled)
Active: active (exited) since Thu 2016-04-28 09:13:02 CEST; 17s ago
Process: 3798 ExecStart=/bin/true (code=exited, status=0/SUCCESS)
Main PID: 3798 (code=exited, status=0/SUCCESS)
CGroup: /system.slice/openvpn.service
Apr 28 09:13:02 raspb13 systemd[1]: Started OpenVPN service.
pi@raspb13:~ $
pi@raspb13:~ $ kplex -d9 -f kplex.conf.udp
kplex DEBUG: Using config file kplex.conf.udp
kplex DEBUG: kplex starting, config file kplex.conf.udp
Segmentation fault
Code:
pi@raspb13:~ $ cat kplex.conf.udp
# For advanced manual configuration, please visit: http://www.stripydog.com/kplex/configuration.html
# Please do not modify defaults nor OpenPlotter GUI settings.
# Add manual settings at the end of the document.
###defaults
[udp]
name=system_input
direction=in
optional=yes
address=127.0.0.1
port=10110
device=lo
pi@raspb13:~ $