• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
usb hub to use with the dvb-t dongle
Hi all,

the openplotter site states you must use a self powered usb hub to power the dvb-t receiver.  All I can find around are 120 volt powered usb hub.

I purchased one but when hooked up the tab on open plotter about ais stays blank and I get the colored square in the corner.  So I feel it is not able to output enough juice to make it work.

would this work for a hub: https://www.amazon.ca/MakerSpot-Stackabl...ry+usb+hub

if not any suggestion, a hub that works on 5 or 12 volt?

many thanks,

i have been looking at this one.
little square means power to rpi is to low
This is a very informative article. I also agree with your post title and you have really well explained your point of view. I am very happy to see this post. Thanks for sharing with us. Keep it up and share more such related posts.

Forum Jump:

Users browsing this thread: 1 Guest(s)