I don't seem to be able to both use the wlan0 as an access point and connect to the internet with the Eth0 connection (on my Rpi 3). I thought when I checked the box in openplotter WiFi AP for Sharing internet device as eth0 that would allow an internet connection over eth0, but that does not seem to be the case. I tried enabling the bridge to eth0, but that did not work either. The only way I can get the eth0 to connect to the intenet is to turn off the Access Point. I am correct in this or have I missed something.
thanks,
Ron
The other issue I have is that even though the Access point is started at start up, my kbox does not connect until I go the NMEA 0183 tab and click on Restart. Do I need to have the kbox start before OpenPlotter on Rpi (I will check that configuration)?
Ron
thanks,
Ron
The other issue I have is that even though the Access point is started at start up, my kbox does not connect until I go the NMEA 0183 tab and click on Restart. Do I need to have the kbox start before OpenPlotter on Rpi (I will check that configuration)?
Ron