This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
One Wire serial number selection
#1
When there are more than a handful of one wire temperature sensors involved, it gets awkward to select a serial number that goes with a particular measurement.
I seem to remember that at one time, when selecting sensor ID's to assign, only the ID's that were not assigned showed up. Now maybe my brain is getting a bit fuzzy and this didn't actually happen but it would be a better way of going than the current method where I have to manually figure out if a particular serial number has been assigned or if it is free.
The current method is of value in certain circumstances but it would be really nice if we could have a choice of displaying all serial numbers or only the serial numbers that are currently not assigned.
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)