|
No humidity and no IMU sensor reported
|
2017-12-22, 09:37 AM
What version openplotter are you using? There should be a compass tab to set up and calibrate the mpu, doesn't seem to be there on your screen shot.
Sent from my SGP511 using Tapatalk
2017-12-30, 11:02 PM
Hi,
I also have the same problem: - module MPU 9255 connected - sudo i2cdetect -y 1 shows 68 - OpenPlotter version was 0.10.0 and no IMU detected in the I2C tab, strange enough, the tab Compass is missing ! - I just upgraded OpenPlotter to the 0.16 Beta and the IMU is now detected and it is running 
2017-12-31, 10:00 AM
2018-06-07, 05:39 PM
I too have a bit of this problem. I have no humidity detected.
pi@openplotter:~ $ sudo i2cdetect -y 1 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- 1e -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- 6a -- -- -- -- -- 70: -- -- -- -- -- -- -- 77
2018-06-07, 11:16 PM
(2018-06-07, 05:39 PM)Havnjero Wrote: I too have a bit of this problem. I have no humidity detected. bmp 280 is temp pressure only bme 280 has the humidity https://www.youtube.com/watch?v=0aL1PxK3rkE
2018-06-16, 11:58 AM
I have an STM LSM9DS0, which supposedly is a bme chip.
thats a imu."compass" not a bme chip.
https://sailoog.gitbooks.io/openplotter-...ensor.html https://sailoog.gitbooks.io/openplotter-...nsors.html |
|
« Next Oldest | Next Newest »
|
