2017-11-16, 11:32 PM
I have sensor for temperature and pression and I can see the values in SK Diagnostic window.
If I remove power, on successive power up the pressure is reported zero and the temperature -271
The only way to have back the correct values is to open NMEA 0183 generator window, delete all listed sentences and hit the “opencpn default” button.
Roberto
====
Open plotter 0.16.0 beta
Raspberry PI 3
Keyboard, mouse, video, GPS, Eth
If I remove power, on successive power up the pressure is reported zero and the temperature -271
The only way to have back the correct values is to open NMEA 0183 generator window, delete all listed sentences and hit the “opencpn default” button.
Roberto
====
Open plotter 0.16.0 beta
Raspberry PI 3
Keyboard, mouse, video, GPS, Eth