2018-01-07, 01:34 PM
(2018-01-06, 07:47 PM)tocan Wrote: I did now decide for next year not to use the hat, because i did bought me for AIS a used class A transponder und was allways most important for me to support Openstreetmap and Openseamap project so i decide to log with the official Datalogger there. in general this way i have place for another head.
http://wkla.no-ip.biz/ArduinoWiki/doku.p...uino:oseam
http://www.cns.se/Products/AIS_Mobile_Transponders
When the new version of openplotter will come? I like during winter to setup the final system at home. For Inland still OpenCPN is only parial usefull because of not existing use of mtiles and tiles.
The hat looks great I like the idea of putting the gps on the hat. My experience with temp sensors attached to a hat is not a good idea generally as the RPI gives off heat causing incarcerate readings.
I agree with Tocan I support Openseamap /openstreetmap. But with no tiles available for my area or i have not found a way to do this. My current setup is a UPS pico with your proto board on top. and the following lines broken out 3.3v,ground, SDA,SCL,1Wire and the serial lines. this goes to another box via Cat6 cable with the i2c sensors. I made a 1w bus on this and Terminals for the serial port.
I am hoping to find RJ45 jacks i can connect the 2 boxes with. I have issues with UPS PICO as they have been very unreliable getting updates out to fix bugs due to proprietary dev software.
I do not use AIS as no one has this on lake Winnipeg. I have non nmea Depth sounder to be replaced suggestions welcome. My second depth sounder is a old wrench tied to 33m tape measure. very high teck accurate to 1 cm.
I stopped using node red on RPI as it has issues so I run it on the laptop to display Sensor data and SignalK Instrument panel.
I use 2 Epsolar tracer A charge controllers via modbus/USB and some python code to send data to SignalK.
Everything is vary stable now. i had a few bad unrelated updates that were causing problems but thanks to some help all is good.
I would like to add RFTAG sensor i could attach to my PDF so if i fall off my boat would stop or alarm if i fall off.