This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ADS1115 Change decimal place
#1
Hello, everyone,
I'm facing a problem.
I want to measure voltage with an ADS1115. So far, so good. I followed the docu procedure and get values. However, my output value shows 7000.00 V. However, a voltage source with 7 V is connected. How can I change the decimal place?
Greetings Jürgen
Angel  Entschuldigung für mein Englisch. Es ist "google english"
PN bitte auf german.  Big Grin
  Reply
#2
(01-13-2018, 11:11 AM)Luckbert Wrote: Hello, everyone,
I'm facing a problem.
I want to measure voltage with an ADS1115. So far, so good. I followed the docu procedure and get values. However, my output value shows 7000.00 V. However, a voltage source with 7 V is connected. How can I change the decimal place?
Greetings Jürgen
Add in the openplotter_analog.conf [ADS1115_X] Section
adjust_points = [[0.0,0.0],[7000.0,7.0],[20000.0,20.0]]

You can add more points to the line if you have non linear values.
  Reply
#3
It's works!
Thanks
Angel  Entschuldigung für mein Englisch. Es ist "google english"
PN bitte auf german.  Big Grin
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)