To reduce some of the fragile wiring clutter, and in light of feedback that interference isn't a problem, I have soldered the IMU and Barometer/Humidity sensor to the proto breadboard hat. I'll run spaghetti wire underneath to wire it up. I'll have to figure out how to mount the Pi in a fixed position. Perhaps upside down from the lid of my enclosure. I'm not concerned about screwing up the temperature reading. The Nasamarine NMEA Wind instrument has that, and adding another probe to onewire is not a problem.
![[Image: 12994560.jpg]](http://www.neobits.com/images/tr8734250/12/12994560.jpg)
I am thinking of stacking something like this with the pi. I could put the front panel (switches, buttons and LEDs) on one, the onewire stuff on another, the water level indicators on a third, adc on the last perhaps. Better ideas for interconnecting things?
I am thinking of stacking something like this with the pi. I could put the front panel (switches, buttons and LEDs) on one, the onewire stuff on another, the water level indicators on a third, adc on the last perhaps. Better ideas for interconnecting things?