• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP USB manager tab : USB Manager and Add windows stay empty
#1
Hello happy OPists !

I have tried many usb peroipheral and wanted to make some housekeeping in the USB and NMEA tabs.
I have suppressed all usb lines from NMEA tab (only left 4 lines unchanged : system_a, system_b, opencpn and signal K.
I have also removed any line in USB Tab. Then rebooted and ran AutoSetup.

Seems it was a mistake, as USB manager is empty, and Add windows is empty too !

Any suggestion ?
Config : RPi 3, OP 0.17 beta
Cordialement
Didier B



  Reply
#2
I would use the linux command
"lsusb"
or
ls /dev/tty*
to test if linux / raspberry does recognize your devices.
Connect and disconnect a device should show different results.

Openplotter USB Manager does only create one file. You can delete it, if your USB-manager list is empty.
"sudo rm /etc/udev/rules.d/10-openplotter.rules"
  Reply
#3
(01-19-2018, 03:42 PM)e-sailing Wrote: I would use the linux command
"lsusb"
or
ls /dev/tty*
to test if linux / raspberry does recognize your devices.
Connect and disconnect a device should show different results.

Openplotter USB Manager does only create one file. You can delete it, if your USB-manager list is empty.
"sudo rm /etc/udev/rules.d/10-openplotter.rules"

Thanks for your answer, which is so useful !
FYI, I tried the lsusb, which showed the connected peripherals OK.
I will keep a note that in case of problem with population of USB tab window I should delete that file.

Btw, what about adding a section "What to do if (or when)..."  to the documentation ?

Anyhow, the use of the delete button in the NMEA ans USB tab seems full of danger ...
Config : RPi 3, OP 0.17 beta
Cordialement
Didier B



  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)