This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Regular polling and inclusion of GPIO sensors in signalk
#1
As I have mentioned previously, the state of various GPIO sensors set up on gpio tab is not regularly polled and shown in signalk output. This seems to be by design, I think it was said they only show up on change. But using various mobile apps and signalk plugins it would be nice to be able to report whether something is on or off, and to see that the sentence is available to report on.

I expect this could be done with node red but would rather not have that running if it could be avoided.





Sent from my Moto G (5) Plus using Tapatalk
Reply
#2
(2018-02-03, 07:25 PM)Saqqara Wrote: As I have mentioned previously, the state of various GPIO sensors set up on gpio tab is not regularly polled and shown in signalk output. This seems to be by design, I think it was said they only show up on change. But using various mobile apps and signalk plugins it would be nice to be able to report whether something is on or off, and to see that the sentence is available to report on.

I expect this could be done with node red but would rather not have that running if it could be avoided.





Sent from my Moto G (5) Plus using Tapatalk


+1
Reply
#3
My experience is, that you have to restart GPIOs to get an actual status.
When a GPIO statuts changes, it is sent.
With node red, you can repeat an old status periodicaly.

I would like a function in OP to actualize the GPIO status in certain time intervals.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)