I’m trying to get VNC viewer working. I get m4ssage that user or password is invalid. I can log on to the openploter network just fine. I have reset password and I’m using user name “pi”. I have run out of ideas?
I just downloaded VNC Viewer to the iPad and it works OK. Could you perhaps post a screenshot of the failure?
Same here, all works fine on my iPad with VNC viewer. Make sure you have enabled VNC in Raspberry options, then the correct ip, and then login: pi; password: raspberry
(2018-06-10, 03:55 PM)Barentsailor Wrote: [ -> ]Same here, all works fine on my iPad with VNC viewer. Make sure you have enabled VNC in Raspberry options, then the correct ip, and then login: pi; password: raspberry
I get on the iPad, “ERROR username was recognized or paswatd was incorrect” I have reset paswarded and reboot but still get the same thing. I can look into theip’s nework ok.
Well I still think a screenshot of the error might help.
(2018-06-10, 07:20 PM)baltika_no_9 Wrote: [ -> ]Well I still think a screenshot of the error might help.
See attached
(2018-06-10, 07:42 PM)addboy Wrote: [ -> ] (2018-06-10, 07:20 PM)baltika_no_9 Wrote: [ -> ]Well I still think a screenshot of the error might help.
See attached
Mmm, I don't seem to see anything attached.
Again
Photo to large to upload.
have you change the password , using some special national characters ?
Apple ( ios) and Linux use diferent code pages .
i have seen this problem with some routers .
I don’t think so? It is the password used to log into the WiFi on the pi? Or is it the VNC account password?