2019-01-30, 12:31 AM
Hi,
I have a NASA Clipper Tactical Wind system that i finally have gotten to play well with my OpenPlotter gear.
Now, to use the True Wind functionality i need to send RMV (or VHW) to the instrument.
I am running 1.2.0 alpha with a Moitessier Hat and a lot of different paraphernailia (promise, more questions later)
How do i set up the system to send a signal, NMEA RMV, out to the USB/RS232 Serial interface? In earlier versions this was possible but now i can only "Add Network" in the Kplex section
Maybe i could add something in the "Advanced " config manually but i could use some guidance. The input from the NASA wind looks like this:
[serial]
name=wind
direction=in
optional=yes
filename=/dev/ttyOP_wind
baud=4800
Greatly appreciate any help withthis!
/Micael
I have a NASA Clipper Tactical Wind system that i finally have gotten to play well with my OpenPlotter gear.
Now, to use the True Wind functionality i need to send RMV (or VHW) to the instrument.
I am running 1.2.0 alpha with a Moitessier Hat and a lot of different paraphernailia (promise, more questions later)
How do i set up the system to send a signal, NMEA RMV, out to the USB/RS232 Serial interface? In earlier versions this was possible but now i can only "Add Network" in the Kplex section
Maybe i could add something in the "Advanced " config manually but i could use some guidance. The input from the NASA wind looks like this:
[serial]
name=wind
direction=in
optional=yes
filename=/dev/ttyOP_wind
baud=4800
Greatly appreciate any help withthis!
/Micael