OpenMarine

Hello Sailors,

I am usig RPI 3 and the official raspberry power supply. I flashed and OP 10 image in a SD card (512Gb, formatted with SD Formatter and then transformed in FAT32 via diskutil console command in a Mac) and inserted the SD on the PI. I got the END KERNEL PANIC - NOT SYNCING: ATTEMPETED to kill init! exit code=0x0000004 and the system does not booting. (please see attached screen print)

I was using OP 8 before and installed the 10 version and had no problem like it before.

Please can somebody help me to solve it?

Thanks a lot!

Best

Paulo

I don't think this post concerns Pypilot - you will want to ask in the Openplotter area of the forum where it may be seen by more people.

Moved to openplotter forum.

Were you using that huge SD card before? I think you can not format as fat32 if the card is more than 32GB using some tools. Have you tried Etcher? https://www.raspberrypi.org/documentatio.../README.md

(2019-05-09, 05:32 PM)Saqqara Wrote: [ -> ]I don't think this post concerns Pypilot - you will want to ask in the Openplotter area of the forum where it may be seen by more people.

Hi Saqqara isn't it  OpenMarine  ›  OpenPlotter  ›  General discussion? The idea is having more people helping![url=http://forum.openmarine.net/forumdisplay.php?fid=2][/url]

---

(2019-05-09, 08:10 PM)Sailoog Wrote: [ -> ]Moved to openplotter forum.

Were you using that huge SD card before? I think you can not format as fat32 if the card is more than 32GB using some tools. Have you tried Etcher? https://www.raspberrypi.org/documentatio.../README.md

Yes I did it using Etcher which format in other format different of FAT32 (because the size of the card) and then I transformed in into FAT32. It already worked before several times with the same card. Now I have this message!!!
Thanks for moving the thread to the right place!

Paulo