OpenMarine

Continuing with the assembly of a Raspi mobile with a 7" screen, I installed the IMU9250.
After the corresponding calibration it works perfectly.
The problem is that the atmospheric pressure comes out in inHg(inches of mercury).

I have tried with the Hut Moitesier and I also get it in inHg

I've looked at Signal K and I don't see the possibility of converting it to millibars.

Does anyone know how to do it?

SignalK uses SI units (for pressure Pa).
Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked?
If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only))

e-sailingSignalK uses SI units (for pressure Pa).
[quote pid='9117' dateline='1559928543']
Do you see the wrong value in "diagnostic Signal K input" when "private Unit" is unchecked?
If it does show you the correct value in Pa then you must change your "Unit Settings" (Setup your private Units (for diagnostic only))
[/quote]

Thank you very much for your reply.

What you propose I have already done, but the value does not change only the units