2020-06-24, 11:14 PM
Pages: 1 2
2020-06-26, 01:57 PM
Hello,
Once installed as indicated by LAZZZ, restarts signalK.
Then you go to / Server / Plugin config and you will see a line 'Raspberry-Pi 1-Wire'
Click on it, validate the mention 'Active' and configure your device by giving its ID N ° and the SignalK key (without adding 'environment' in front.
I need the outside temperature, I put the N ° ID of my probe and I write outside.temperature in the SignalK key section. (This key is read by Opencpn if you add the dashboard 'temp Air' for example)
Cordialy
Once installed as indicated by LAZZZ, restarts signalK.
Then you go to / Server / Plugin config and you will see a line 'Raspberry-Pi 1-Wire'
Click on it, validate the mention 'Active' and configure your device by giving its ID N ° and the SignalK key (without adding 'environment' in front.
I need the outside temperature, I put the N ° ID of my probe and I write outside.temperature in the SignalK key section. (This key is read by Opencpn if you add the dashboard 'temp Air' for example)
Cordialy
2021-01-17, 06:53 PM
Updated openplotter-gpio v2.1.0 with support for 1W sensors:
https://forum.openmarine.net/showthread....4#pid17814
https://forum.openmarine.net/showthread....4#pid17814
Pages: 1 2