2017-02-15, 04:33 PM
Hi
Bought a combined I2C sensor with MPU-9250 and BMP180.
The sensor is recognized on the I2C page as MPU-9250, SK diagnostics show some information.
There is button "calibrate" in 0.9.0 on the I2C tab. is there some information about how to calibrate this sensor ?
After pushing this button no information pops up... is this correct ?
I saw in another post,
this brings up the calibrator as explained on this page
--> I assume you can do it in the lab by moving around the sensor.
But should i recalibrate once installed on the boat ?
--> This would be difficult with 200 smaples in each octant
anybody experience with this ?
Thanks in advance !
Bought a combined I2C sensor with MPU-9250 and BMP180.
The sensor is recognized on the I2C page as MPU-9250, SK diagnostics show some information.
There is button "calibrate" in 0.9.0 on the I2C tab. is there some information about how to calibrate this sensor ?
After pushing this button no information pops up... is this correct ?
I saw in another post,
Code:
cd /home/pi/.config/openplotter/imu
RTIMULibDemoGL--> I assume you can do it in the lab by moving around the sensor.
But should i recalibrate once installed on the boat ?
--> This would be difficult with 200 smaples in each octant
anybody experience with this ?
Thanks in advance !