Hi everyone,
I'm trying to install my new Moitessier HAT and it seems the Pre-installed drivers are out of date. I get an error that says the Kernel is wrong. The Kernel driver in the OpenPlotter package is 5.4.79 -v7 and my Kernel is 5.10.60 -v7. Where can I get the correct drivers?
(2021-09-10, 09:01 AM)rfe3 Wrote: [ -> ]Hi everyone,
I'm trying to install my new Moitessier HAT and it seems the Pre-installed drivers are out of date. I get an error that says the Kernel is wrong. The Kernel driver in the OpenPlotter package is 5.4.79 -v7 and my Kernel is 5.10.60 -v7. Where can I get the correct drivers?
Ciao,
you should send a request to:
https://www.rooco.eu/2018/06/13/firmware...ssier-hat/ - usually update again and quickly.
I'm waiting for this update too.
Or ask Sailoog.
Thanks, I sent them a message, hopefully they react quickly...
Normally you can download them from the Rooco site under download.
Dries
Hi Dries,
Yeah, the Drivers on the Download page are not updated, the're only 5.10.52 and the newest Kernel is 5.10.60. Hopefully they'll get on it soon I really want to play with my new Toy....
(2021-09-16, 05:46 AM)SkipperEarly Wrote: [ -> ]Done, thanks!
Do you mean the new Drivers are finished? Where are they posted? I didn't find them on the Rocco DL page.
just click update within op/moit../driver and bingo
Ok, I downloaded and it installed but I'm still getting errors about kernal not supported. When I pushed update I saw a Green flash of 5.10.60.
[
attachment=1576]
[
attachment=1577]
Nevermind, I think I got it. I reinstalled the Hat from the Settings Menu then the driver showed up in the drop down menu.
Thanks...