OpenMarine

Full Version: OP 3 and Signal K 1.45 CAN bus
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hello,

my OP 3 on a Raspi 4B 2GB on a MCS board was up and running well together with my seatalk ng network until I updated Signal K to version 1.45.
Now Signal K receives no data anymore from the n2k network.

Has anybody an idea how I can fix that   or
How I can get back to Signal K 1.44?

Regards
Thomas
my n2k hat works as before. check your cables.
Definitly not a cable issue
my CAN0 init looks so:

: dmesg | grep can0

[ 7.582699] mcp251x spi0.0 can0: MCP2515 successfully initialized.
[ 8.706944] IPv6: ADDRCONF(NETDEV_CHANGE): can0: link becomes ready
I reinstalled Signal K 1.44.0 and the CANBUS data was visible again in CPN. There must be something not running well. I gave it also to the Signal K community but they refuse any issue neither.

Regards
Thomas