2023-07-09, 10:43 AM
Hello,
I am in the process of installing pypilot on may day sailor. Main components are a rasperrypi 4, Sean‘s pypilot hat and motor controller I bought through Sean‘s store.
Due to the locations I have to install the rasperrypi and the location for the motor controller, I have to extend the cable between the rasperrypi hat and the controller. Easiest way would be to make an extension cord using the original connectors. This would give me the needed flexibility.
Can someone provide me with the type/make of the waterproof connectors used in Sean‘s design (see pic attached)?
(Somehow I was not successful to find that information on the official pages, searching the forums or the net in general
)
Thank you in advance.
Mike
I am in the process of installing pypilot on may day sailor. Main components are a rasperrypi 4, Sean‘s pypilot hat and motor controller I bought through Sean‘s store.
Due to the locations I have to install the rasperrypi and the location for the motor controller, I have to extend the cable between the rasperrypi hat and the controller. Easiest way would be to make an extension cord using the original connectors. This would give me the needed flexibility.
Can someone provide me with the type/make of the waterproof connectors used in Sean‘s design (see pic attached)?
(Somehow I was not successful to find that information on the official pages, searching the forums or the net in general
)Thank you in advance.
Mike