I have a DST800 Triducer (NMEA 0183) that I'm trying to connect to my OP V2 using a USB to RS422 adapter. I have correctly connected the wires (R+ and R-), and the Receive LED flashes RED. The transducer is receiving 13V. The OP V2 recognizes the device in the serial tab, and I connected it to serial K using AUTO at 38400 Baud. However, when I added it to connections in OPEN CPN, it showed up as 4800 baud. Despite all this, I'm not getting any response for temperature, depth, or speed. It's important to mention that I'm testing this setup in my office before installing it. My RPI V3b+ works fine with the Serial GPS. I'm not very familiar with these processes, so I must be missing something. Can anyone help me troubleshoot this issue? Thank you!
(2023-08-12, 12:09 PM)DaveGraves Wrote: [ -> ]I have a DST800 Triducer (NMEA 0183) that I'm trying to connect to my OP V2 using a USB to RS422 adapter. I have correctly connected the wires (R+ and R-), and the Receive LED flashes RED. The transducer is receiving 13V. The OP V2 recognizes the device in the serial tab, and I connected it to serial K using AUTO at 38400 Baud. However, when I added it to connections in OPEN CPN, it showed up as 4800 baud. Despite all this, I'm not getting any response for temperature, depth, or speed. It's important to mention that I'm testing this setup in my office before installing it. My RPI V3b+ works fine with the Serial GPS. I'm not very familiar with these processes, so I must be missing something. Can anyone help me troubleshoot this issue? Thank you!
This thread is eerily similar!
https://forum.openmarine.net/showthread.php?tid=2343 Are you a bot "Dave" or really looking for help?..............thought so.