OpenMarine

Hello everybody

I'm trying to setup a new instal PI5 +NVVME + MacHartur HAT

When I try to install CAN COnnection adding a new MCP251xdf device I'm not able to select the power GPIO 25, I always get the message "you can not select GPIO to do this job.

Anu Idea will be appreciated

Regards

You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.read...inout.html

(2025-03-21, 07:29 PM)Sailoog Wrote: [ -> ]You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.read...inout.html

Hello

Thanks a lot!