Full Version: Had to replace mine
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I bought one of these a while ago, and I tested it successfully with the rpi setup. Only when I added all other inputs, it stopped translating sentences. Paste from my slack #support message: 

I’m losing n2k sooner or later on every reboot. If I start canbus manually, I get
```signalk-server-node $ actisense-serial /dev/n2k
FATAL 2017-07-30T18:50:57.385Z [actisense-serial] Unable to read from NGT1 device
after 1, 10 or 100 lines. Is this normal? I’m using the can-usb from openplotter rather than the ngt-1. Any ideas anyone?

After replacing the dongle I bought from openplotter with an NGT-1, n2k works fine again