problems with usb bridge / Logilink Serial adapter - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: problems with usb bridge / Logilink Serial adapter (/showthread.php?tid=1187) |
problems with usb bridge / Logilink Serial adapter - glowntiger - 2018-05-31 Hi, i have the following Problems. I used a openplotter on a Pi3. I have a second USB WiFi Adapter, a keybord, a mouse and a Logilink Serial Adapter with 8 Ports (AU0033) on USB. The Software works fine with WIFI Bridge and the USB mouse and keybord. If I plug in the Logilink all other devices on USB doesn´t work. But the devices are still listed in lsusb. Over VNC I can use the the Logilink and it was find from openplotter. If I used rasbian Jessie without openplotter all works fine. Have anybody a Idea? Sorry for my english. Thomas RE: problems with usb bridge / Logilink Serial adapter - Luckbert - 2018-05-31 Hi glowntiger, which version do you use? RE: problems with usb bridge / Logilink Serial adapter - Sailoog - 2018-05-31 openplotter v1.0.0 is rspbian stretch, have you tested this on clean rasbian stretch? This smells like powering issue RE: problems with usb bridge / Logilink Serial adapter - glowntiger - 2018-06-05 Hi, yes it was a clean openplotter v1.0.0. No further configurations. On a clean stretch without openplotter on the same Pi (another card) all works fine... I have also tested with a powerded hub on openplotter. Also with forced powered usb... (config.txt) |