Headless Access Point Mode - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Headless Access Point Mode (/showthread.php?tid=125) |
Headless Access Point Mode - alex060 - 2016-05-28 Hi, I am trying to setup open plotter headless mode with an AP but I seem stuck any advice would be appreciated. RPI 2 OpenPlotter 0.8 (Checksum is ok) Write image to SD card with dd load up boot drive edit config.txt with; - device=wlan0, SSID , password etc Boot up and no AP appears To troubleshoot: - connect serial cable - boot is normal, login as pi and sudo to root - ifconfig shows wlan0 without ip address - lsusbĀ Bus 001 Device 004: ID 148f:5370 Ralink Technology, Corp. RT5370 Wireless Adapter so I figure better check my work, go to /boot/ and check config.txt i note everything i have changed is there except it just has "device=" no wlan0 so I use nano (with sudo) and edit it again, close, open it again and check changes are present reboot and get the same result. For a laugh I copy config.txt to config.txt2 and reboot and I can see both files. config.txt2 is good and config.txt has changed again. I am sure I am doing something stupid but I can't figure it out. Any help would be appreciated. Cheers, Alex RE: Headless Access Point Mode - Sailoog - 2016-05-31 strange behavior. Activate AP editing boot/config.txt with default values. Run openplotter, connect by serial and type Code: nano /home/pi/.config/openplotter/openplotter.conf if the section [WIFI] contains the correct values, type Code: sudo python /home/pi/.config/openplotter/wifi_server.py 1 Any error? |