Use eth0 to share connection to switch - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Feature Requests (https://forum.openmarine.net/forumdisplay.php?fid=5) +--- Thread: Use eth0 to share connection to switch (/showthread.php?tid=128) |
Use eth0 to share connection to switch - snowboarder - 2016-06-03 Hi I use openplotter in access point mode , now i want to connect a network switch to the eth0 port and use the internet connection from openplotter with the devices connected to the switch. when i now connect a switch to the eth0 (lan) the devices dont get a ip adres from openplotter is there a option to do this ? RE: Use eth0 to share connection to switch - e-sailing - 2016-06-03 Yes, but only alpha (v0.9.0) at the moment. What you seek is "Enable bridge to eth0". Also useful for plotter with ethernet connector (gofree mode). Or to connect a notebook over ethernet to the raspi. (Use a crossover Ethernet cable). I think on a hub you don't need the crossover cable if you have an uplink port. But you are in the wrong thread/category! RE: Use eth0 to share connection to switch - snowboarder - 2016-06-04 Thanks I will try to upgrade to alpha (v0.9.0) and see if i can connect the switch |