![]() |
filetransfer with x11vnc - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: filetransfer with x11vnc (/showthread.php?tid=132) |
filetransfer with x11vnc - SkipperEarly - 2016-06-08 would like to use the file transfer facility of x11vnc to update charts, polars and Opencpn settings from my PC. On the PC I run win10 and RealVNC. In the default startup of VNC server within OP the file transfer is not enabled and I could not find where in which config file I could set this. So I started another x11vnc session and enabled the f/t option. However when connecting from the PC the session shown that the option is not allowed. Has anyone tried/solved this ? Thanks for advise. RE: filetransfer with x11vnc - PaddyB - 2016-06-08 I use filezilla on a win7 laptop connected over wifi. Sent from my SGP511 using Tapatalk RE: filetransfer with x11vnc - Sailoog - 2016-06-09 Have you tried Menu>Internet>X11VNC Server? RE: filetransfer with x11vnc - Tacmed - 2016-06-14 Sudo apt-get install ftpd This loads an ftp server. I found it quicker to remove the microsim and dump the charts directly to the chart folder. It saved having an ftp server chewing up cpu time for a rare use. RE: filetransfer with x11vnc - SkipperEarly - 2016-06-16 (2016-06-09, 10:08 AM)Sailoog Wrote: Have you tried Menu>Internet>X11VNC Server?yes, enabled transfer but without success |