Send PGN with GPS position data to Ray60 VHF radio - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Send PGN with GPS position data to Ray60 VHF radio (/showthread.php?tid=1342) |
Send PGN with GPS position data to Ray60 VHF radio - bhavers - 2018-07-25 Hi, my Rayamrine Ray60 VHF/radio does not pick up the GPS positioning data that i send out with OpenPlotter 1.0.0 on a Pi with Moitessier HAT and CAN-USB. I know that OP is broadcasting the positioning data, because i can see it on my Raymarine i70s displays. So it is on the NMEA2000 / STNG network. I suspect that the radio/vhf expects another PGN (129029), than OP is currently sending (129025) because: - the Ray60 manual indicates (at page 112) that it expects 129029 GNSS position data. http://www.raymarine.nl/view/?id=10805 - In OpenPlotter i see on the CAN tab that it sends PGN 129025 Position (and PGN 192026 SOG). But it does not send PGN 129029. How can i manually add PGN 129029 to the SignalK to N2K converter? Kind regards, Bram. RE: Send PGN with GPS position data to Ray60 VHF radio - sonas - 2018-08-01 Hi Bram, How did you manage to send information to your Raymarine? I did connect the Openplotter converter and I do receive the information from my Raymarine bus (i70). The information I send from Openplotter is not shown on my i70. In the 0.x.x version there was a convert to NMEA2000 option available, now in the 1.1.0 version I do not see it anymore. Before there was a huge list of sentences to convert, including something like the device ID of the sending device. Any idea? Thanks, Brian RE: Send PGN with GPS position data to Ray60 VHF radio - bhavers - 2018-08-05 Hi Brian, I am using openplotter 1.0.0. On the CAN tab in OpenPlotter i have selected Enable N2K output. On that same tab i selected "Signal K to N2K converter", and there i have selected System Time, Heading, Attitude, Positing_Rapid, SOG_COG. Than i will immediately see the positioning information on my i70s. But i will not transmit AIS data or the GPS data in the right PGN/sentence for my VHF radio. Still looking how that can be fixed. I was just looking through the code: https://github.com/sailoog/openplotter/blob/master/N2K-from-SK.py The list of PGNs i see in OpenPlotter CAN tab (when i press the "Signal K to N2K converter" button) seems to be hardcoded in there. I thought it was an extendable list. I will ask sailoog if i can extend this myself. Gr. Bram. RE: Send PGN with GPS position data to Ray60 VHF radio - sonas - 2018-08-06 (2018-08-05, 10:53 PM)Hi Bram,I think I used the same values, I\ll try again.If you scroll trough the setup on the raymarine, do you find the Openplotter device in a list of transducers?Adding our own PGNs would be nice!Thanks Wrote: On that same tab i selected "Signal K to N2K converter", and there i have selected System Time, Heading, Attitude, Positing_Rapid, SOG_COG. |