OpenMarine
AIS - Printable Version

+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2)
+--- Thread: AIS (/showthread.php?tid=1359)



AIS - jim321 - 2018-07-31

i just got a new usb hub so this is the first chance i've gotten to test my ais. i cant seem to get the calibration to work it will pop up the terminal and see's the ais dongle but does not put out any data. the take a look window flashes then disappears,the check band errors out on all bands.. it shows up in the startup window and lsusb.tried on 1.0 and updated 1.1 same behavior.. 
rpi3
v1.1.0

Found 1 device(s):
0: Generic, RTL2832U, SN: 77771111153705700

Using device 0: Generic RTL2832U
Found Rafael Micro R820T tuner
Supported gain values (29): 0.0 0.9 1.4 2.7 3.7 7.7 8.7 12.5 14.4 15.7 16.6 19.7 20.7 22.9 25.4 28.0 29.7 32.8 33.8 36.4 37.2 38.6 40.2 42.1 43.4 43.9 44.5 48.0 49.6
[R82XX] PLL not locked!
Sampling at 2048000 S/s.
Reporting PPM error measurement every 10 seconds...
Press ^C after a few minutes.
Reading samples in async mode...


RE: AIS - jim321 - 2018-07-31

OK just a crappy hub..tried all 7 ports with nothing else attached . plugged into pi's usb it complains about power but works.
waiting on a new hub..