NEO-M8N Flight Controller GPS Module with On-board Compass - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: NEO-M8N Flight Controller GPS Module with On-board Compass (/showthread.php?tid=2031)

NEO-M8N Flight Controller GPS Module with On-board Compass - jim321 - 2019-10-13 has anyone looked into using these compass gps combo.?  serial + i2c https://www.aliexpress.com/item/32987780612.html?spm=a2g0o.productlist.0.0.76cd1cabpn4fd9&algo_pvid=a32c8a6f-a815-486d-8bd9-bc2a7c5f7f19&algo_expid=a32c8a6f-a815-486d-8bd9-bc2a7c5f7f19-25&btsid=4501c5d4-97fe-4055-baf1-506df98d21d5&ws_ab_test=searchweb0_0,searchweb201602_5,searchweb201603_55 NEO-M8N Flight Controller GPS Module with On-board Compass - abarrow - 2019-10-13 I got a module with the same connections. It turned out only the IMU was I2C. The GPS was serial. I did nothing else with it. Sent from my CLT-L04 using Tapatalk RE: NEO-M8N Flight Controller GPS Module with On-board Compass - jim321 - 2019-10-13 i am building a basic device for the dingy with a opizero and a 7'' display . i think i'll get one and try it out . thats how i expected it to be connected serial +i2c i have been using just a gps opencpn & signalk on it. displayed on mobil devices, i figured while updating the display i might as well add a compass. RE: NEO-M8N Flight Controller GPS Module with On-board Compass - Sailoog - 2019-10-13 be sure the IMU is supported by pypilot: https://github.com/seandepagnier/RTIMULib2 RE: NEO-M8N Flight Controller GPS Module with On-board Compass - jim321 - 2019-10-14 i think it's a HMC5883L i have also seen 6050 on some post that i can't find again..it would make for a clean looking build/install. i have an extra 9255 i am going to use for now. its an Orange pi zero so the pin map is different i'll need to look into that too..i haven't used i2c on it yet i was looking for that page thanks