OpenMarine
Sensor board & python help - Printable Version

+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2)
+--- Thread: Sensor board & python help (/showthread.php?tid=2151)

Pages: 1 2 3

RE: Sensor board & python help - mgrouch - 2020-02-03

(2020-01-07, 01:32 PM)abarrow Wrote: Good idea, or at least a header that can accept a ribbon cable that can plug into a PI. Of course then you'll need to line up mounting holes, Then there's the power to the PI.

Then, of course, the mSATA connector, the safe power/shutdown switch, the USB hub, SEATALK bridge ..... ;-)

(Great job, by the way).

There is a hub board already

http://www.suptronics.com/miniPCkits/x180.html

as well as power and safe shutdown board

http://www.suptronics.com/miniPCkits/x710.html

as well as SATA

http://www.suptronics.com/miniPCkits/x828.html

Might be adding RTC, carbon monoxide and other gases sensors, lightning strike distance sensor

like this one:

https://www.amazon.com/dp/B078N1Q7CJ

would make more sense.

Those would be nice to have.

Thanks,
--MG