+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2)
+--- Thread: OP2 Install (/showthread.php?tid=2326)
OP2 Install - paul42 - 2020-02-13
Hi All, been using OP v1 with OpenCpnV5 which was great. Now building a new Rpi4B system for OP V2
Just downloaded & installed the "Pre-Release Starting OP v2" all no problem.
My question is will a re-flash be needed when the first release candidate is available or will it be able to be done via an update.
I'm not bothered either way, just don't want to bother with all the many small changes if a full re-flash is advised.
Thanks, Paul
RE: OP2 Install - Luckbert - 2020-02-17
Hello, Paul,
Sorry it's so late in the day,
The base app is now stable.
That means you can concentrate on OP2. If there are any changes, these will most likely be offered as an update.
We wish you a lot of fun with OP2
Greetings Jürgen
RE: OP2 Install - paul42 - 2020-02-17
(2020-02-17, 08:20 PM)Luckbert Wrote: Hello, Paul,
Sorry it's so late in the day,
The base app is now stable.
That means you can concentrate on OP2. If there are any changes, these will most likely be offered as an update.
We wish you a lot of fun with OP2
Greetings Jürgen
Thanks, that's as I suspected as it's been totally stable in the week or so I have had it running.
As others have said, a huge thank you for an exceptional project.