opencpn-hat-? nema prefixes - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: opencpn-hat-? nema prefixes (/showthread.php?tid=2390)

opencpn-hat-? nema prefixes - Norm - 2020-02-29 Rpi 4 openplotter noob updated  through the openplotter settings window (the gui's are fantastic!) updated 27/2/20 Moitessier HAT 2 with moitessier_4.19.97_1.5.1_armhf.deb Items which may be opencpn issues  (when looking at the connections in opencpn 10.10.10.1, and specifically the nema Prefix 3 or 5 letter) some are not selected (I found the heel, pitch and pressure, were not there) I also found 2 or 3 version of the AIS prefix not selected? adding the pitch heel, and pressure brought them through to opencpn but using the simulator from the hat (with correct range in opencpn) i am still missing the AIS data. I am pretty sure the data is in K but Maybe the default openCPN setup is ? I am not sure we all say this, but THANKS for OPENPLOTTER!!!!! it is very nice even in bata! One note, I am using a 64G SD I started with gparted,and  two partisions one fat32 and one ext4, I did find running the noob,  that I now have one 63G partition, hope I did not make the above omissions happen via the over 32G ? Also on cold boot, finding the temp and press missing but opening the I2C settings window and selecting each then edit and accept (without any changes) all is connected, I also have needed to do this a couple of times for the serial settings?  (regarding the hat)? Hope this provides some help (or maybe questions) during the bata testing Thanks again : Norm