+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2)
+--- Thread: Serial "There are missing devices" message (/showthread.php?tid=2583)
Serial "There are missing devices" message - grw - 2020-05-16
Hi there
I am trying to get a CANAble Pro connected to OpenPlotter. I reflashed the firmware for the CANAble Pro to use Candlelight and now I can't see the device anymore and am receiving a message "There are missing devices" under the "Serial 2.1.0" "Devices" tab.
Any pointers on how to reset things so that the system isn't looking for the old device would be appreciated.
Thanks and regards
Glenn
Serial "There are missing devices" message - holgerw - 2020-05-17
As the can Modul gets connected to serial, delete both Setting first. Later try to set them again with your updated n2k Module. Good luck.
Sorry - its difficult with my mobile to type.
Holger
RE: Serial "There are missing devices" message - Sailoog - 2020-05-17
We have not tested the candelight firmware yet. You should set it manually: https://canable.io/getting-started.html