OpenMarine
1W support openplotter 2 - Printable Version

+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2)
+--- Thread: 1W support openplotter 2 (/showthread.php?tid=2623)

Pages: 1 2


RE: 1W support openplotter 2 - tjmack - 2020-06-24

Thanks Lazzz! I would never have found that.

Now to figure out how to configure and use...


RE: 1W support openplotter 2 - kinefou - 2020-06-26

Hello,
Once installed as indicated by LAZZZ, restarts signalK.
Then you go to / Server / Plugin config and you will see a line 'Raspberry-Pi 1-Wire'
Click on it, validate the mention 'Active' and configure your device by giving its ID N ° and the SignalK key (without adding 'environment' in front.
I need the outside temperature, I put the N ° ID of my probe and I write outside.temperature in the SignalK key section. (This key is read by Opencpn if you add the dashboard 'temp Air' for example)
Cordialy


RE: 1W support openplotter 2 - Sailoog - 2021-01-17

Updated openplotter-gpio v2.1.0 with support for 1W sensors:

https://forum.openmarine.net/showthread.php?tid=3029&pid=17814#pid17814