+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3)
+--- Thread: [solved] Enable/disable PGNs in can-adapter in OP2? (/showthread.php?tid=2655)
[solved] Enable/disable PGNs in can-adapter in OP2? - Celestine - 2020-06-14
Hi,
In OP1 there was a utility to enable and disable PGNs in the can-device.
Can't find anythin like it in OP2. Is it gone or am I just not searching carefully enough?
I use an Actisense NGT-1 if it matters.Cheers,
Pär W
RE: Enable/disable PGNs in can-adapter in OP2? - Sailoog - 2020-06-16
OpenPlotter - CAN Bus - CAN USB tab: "Open device TX PGNs"
RE: Enable/disable PGNs in can-adapter in OP2? - Celestine - 2020-06-16
Thanks! How could I miss that?
Pär W