[CLOSED] No activity and data in signal K for USB/NMEA but logfiles get them - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: [CLOSED] No activity and data in signal K for USB/NMEA but logfiles get them (/showthread.php?tid=2838) |
[CLOSED] No activity and data in signal K for USB/NMEA but logfiles get them - Phil - 2020-08-11 Hi, I have connected my nmea 0183 loch datas: depth, wtaer temp, ... and logfile is ok for my device: 1597175775146;N;$VWVHW,,,,,00.0,N,00.0,K 1597175775146;N;$PTTKV,00.0,A,00.0,03339.0,00882.7,28.1,C 1597175775147;N;$PTTKD,003.8,A,B 1597175775147;N;$VWVLW,03339.0,N,00882.7,N 1597175775148;N;$VWMTW,28.1,C 1597175775148;N;$SDDPT,003.8,+0.0 1597175775312;N;$SDDBT,012.8,f,003.8,M,002.1,F But nothing in signal K web app (dashboard, databrowser, ...). For my wind data, everything works fine: log files and dash board and databrowser,...). Bug ? Thanks in advance for your help (last version of openplotter installed with signal K 1.26) Best regards Philippe RE: No activity and data in signal K for USB/NMEA but logfiles get them - PaddyB - 2020-08-11 (2020-08-11, 09:20 PM)Phil Wrote: Hi, Your logfile messages don't have checksums, they should look like this > $VWVHW,,,,,00.0,N,00.0,K*4D If you can't get the devices to send with a checksum then in the signalk connection set validate checksum to no and append checksum to yes. Though not all messages are decoded into signalk https://github.com/SignalK/signalk-parser-nmea0183 RE: No activity and data in signal K for USB/NMEA but logfiles get them - Phil - 2020-08-12 Hi, great, you were right, removing the checksum check now it works! Thanks a lot :-) Perhaps write few words in the doc about this behavior... |