Losing GPS signal on OpenCPN - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: Losing GPS signal on OpenCPN (/showthread.php?tid=3067) |
Losing GPS signal on OpenCPN - benco6 - 2020-11-06 Hi I have Openplotter running on Pi3- Ihave a GPS puck plugged in- and I can get a signal from the puck to the OpenCPN. But, if I leave it running overnight- it drops the connection to the puck and I cannot get it to reconnect. Last time, I had to reinstall the software all over again. When i use the Serial utility of the Openplotter software, I get a green connection and when i use the connection utility on OpenCPN, I the drop down presents the USB port, and the name of the puck. Am I doing something wrong? I am using a Beitan GPS receiver puck. It has the u-blox GNSS receiver inside...do I need to get a different puck? Thanks Ben RE: Losing GPS signal on OpenCPN - jim321 - 2020-11-06 does it have a clear view of the sky? unplug &plug back in? when it happens. RE: Losing GPS signal on OpenCPN - mgrouch - 2020-11-06 Are you connected via SignalK? If that what happens if you restart just SignalK? Thanks RE: Losing GPS signal on OpenCPN - Didier B - 2020-11-07 Are you using USB3.0 ? RE: Losing GPS signal on OpenCPN - benco6 - 2020-11-16 Hi- Thank you for the responses- I was not using the USB3 port. Even when I unplugged and plugged back in it did not work. I had tried using Signal K in the past and it did not seem to work- but I reinstalled SignalK this time and it seems to be more stable. I will post again if that changes. RE: Losing GPS signal on OpenCPN - holgerw - 2020-11-17 i had better results with an longer usb cable, versus connecting it direct to the unshielded raspberry. especially usb3-traffic generates some digital noise to the other recievers (ais, radio or gps) |