Cannot get gps in signalK to opencpn - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Cannot get gps in signalK to opencpn (/showthread.php?tid=3116) |
Cannot get gps in signalK to opencpn - ReinierD - 2020-11-28 Rpi 4 noobs last download. opencpn localhost:51000: socket connection refused. So i try port 51000 in stead of 3000 no result, set it back to network port 3000 When I use ttyusbo nmea 1830 in connections opencpn it works and shows nmea debug window, but nothing happens in connectons network-input signal K- localhost- 10110. changed also network port 3000 en 51000. connection pypilot and signal K lookes oke What am i doing wrong or is it a format fault? RE: Cannot get gps in signalK to opencpn - holgerw - 2020-11-28 i did it this way: in serial/openplotter make an connection to gpsd. this will connect the gps to gpsd AND connect gpsd to signalK. in opencpn make ONLY ONE connection to signalk (without autoconnect) thats all you should need. good luck. RE: Cannot get gps in signalK to opencpn - PaddyB - 2020-11-28 Have you added ttyusbo nmea 0183 to signalk in the serial app? RE: Cannot get gps in signalK to opencpn - ReinierD - 2020-11-29 (2020-11-28, 03:16 PM)holgerw Wrote: i did it this way: You are give the solluction. It is working now. But gpsd is used in debian programs. In the manual they talk about signal K. Indead without autoconnect. Txns Reinier RE: Cannot get gps in signalK to opencpn - PaddyB - 2020-11-29 Did connecting the gps to the signalk serial app not work? https://openplotter.readthedocs.io/en/latest/serial/serial_app.html RE: Cannot get gps in signalK to opencpn - holgerw - 2020-11-29 Connecting is the second Step, maybe the Doc is not so clear: https://openplotter.readthedocs.io/en/latest/serial/connecting.html Fine, you get your position at last. Happy boating. RE: Cannot get gps in signalK to opencpn - ReinierD - 2020-11-30 (2020-11-29, 04:42 PM)holgerw Wrote: Connecting is the second Step, maybe the Doc is not so clear: Txns Had a pdf manual download, i sea there is now much more to read. I will proceed now. Is there more over the pypilot motor connection teo read? b4n Reinier |