New member - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: New member (/showthread.php?tid=3251) |
New member - JMac - 2021-02-02 Hi, I am impressed by the amount of knowledge and expertise which I am seeing here. Too much info to know where to begin looking, so I will ask here for help to get me going. I have an old Navico PH8000 Autopilot (I have the Manual) with a hydraulic linear actuator, attached to steering quadrant on (Wheeled) sailing yacht. The gear also includes a heading sensor, a rudder position sensor and a pump. The pump and actuator seem to be working ok. The computer end (JA800 box ) appears to be dying, trouble on holding headings last season and cannot now get down to boat to check it out. I'm computer literate, but I am not an electronics expert. I did install a lot of gear myself by way of chart-plotter, AIS etc. across a Seatalk backbone. I would be happy if I could just achieve the original role of the set up, i.e. going from one position to another in a relatively straight line. Multiple waypoint course following would be a great bonus, but I would settle for the simple solution for the moment. I have 2 questions 1.Would it be worthwhile for me to begin studying PYPilot as a potential solution ( Everything else is on Seatalk) ? 2 Is anyone aware of a solution to my Navico problem - that would allow me to focus on where I need to look and study in here? Many thanks in advance for your help. John RE: New member - JMac - 2021-02-03 I have found where I need to go and have ordered a Raspberry Pi. Im holding off on the Moitessier Hat , as I understand that an upgrade is on the way soon. I might get back here if I hit a technicality wall. |