How to send GNSS/GPS to nmea 0183 usb stick - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: How to send GNSS/GPS to nmea 0183 usb stick (/showthread.php?tid=3349) |
How to send GNSS/GPS to nmea 0183 usb stick - Sea-and-Sea - 2021-03-19 Hey guys, my current setup: Raspberry pi4 Moitessier hat 2 Openplotter lates version Opencpn 5.2.4 FTDI USB nmea 0183 TX/RX stick I'm trying to output GPS/GNSS from the Moitessier hat to nmea 0183 using the USB stick to my VHF radio that has nmea0183 input in Openplotter Serial setup: device ttyUSB0 alias ttyOP_nmea data nmea 0183 connection SignalK id nmea baud 38400 in Opencpn connections setup: type Network Direction Output Protocol UDP Network address 0.0.0.0 Network Port 10119 Priority 1 type Network Direction Input Protocol Signal K Network address local host Network port 3000 Priority 1 type Network Direction Output Protocol UDP Network address 0.0.0.0 Network port 10110 Priority 1 type Network Direction In/Out Protocol UDP Network address 0.0.0.0 Network port 10119 Priority 1 Signal K config ID opencpnOUT data type nmea0183 NMEA0183 Source UDP Port 10119 Sentence Event nmea0183out ID nmea data type nmea0183 NMEA0183 Source Serial Serial port /dev/ttyOP_nmea Baud rate 4800 Output Events nmea0183out Sentence Event nmea0183out the VHF radio says "no gps signal" When i run 'cat /dev/ttyOP_nmea' i get no output reported (same on cat /dev/ttyUSB0 I think i've followed instructions in OpenPlotter, OpenCPN and Moitessier and can't see what i'm doing wrong. Any help greatly appreciated Thanks Colin RE: How to send GNSS/GPS to nmea 0183 usb stick - Didier B - 2021-03-20 (2021-03-19, 11:12 PM)Sea-and-Sea Wrote: Hey guys, my current setup:You might usefully refer to : https://forum.openmarine.net/showthread.php?tid=3331 |