Swapped GPIO switches after update - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: Pypilot (https://forum.openmarine.net/forumdisplay.php?fid=17) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=18) +--- Thread: Swapped GPIO switches after update (/showthread.php?tid=3465) |
Swapped GPIO switches after update - FabianT - 2021-05-28 Hi, yesterday I've updated to the newr image of tinypilot (from october), been running the 2019 version before. The pilot works even better, so thats nice. Two questions: - the gpio buttons to change course (small and big step) swapped directions. + became minus and so on. Can I swap this back in some config? - The "wind" pilot is gone. It seems it switches automatically? The display shows + and - AWA. Buttons are now correct (they where wrong on the old version), but I am afraid this is due to the swapped direction in compass mode? //Fabian Edit: Tinypilot running on RPI Zero. Switches wired to the GPIO pins. RE: Swapped GPIO switches after update - seandepagnier - 2021-05-28 You can reprogram the buttons from the web interface: http://192.168.14.1:33333 It takes a few minutes to load. RE: Swapped GPIO switches after update - FabianT - 2021-05-28 Thanks, I will check that. //Fabian |