+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3)
+--- Thread: How to existing/old nmea0183 systems? (/showthread.php?tid=3485)
How to existing/old nmea0183 systems? - seva - 2021-06-06
Hi,
I'm trying to setup openplotter with an rpi4 on a '99 boat. The boat already has quite some useful equipment like wind meters, compass, gps, ais etc. It's mainly old B&G Network stuff. I'd like to hook up to these without destroying/opening anything in the process, but can't find the connectors for these devices?
Can anyone tell me what the generic type is of the connectors is on (old) standhard horizon plotters and B&G Network gear? If I look for brand + connector, I get cables of 20-50 euro, which seems way over-priced.
Attached are some pictures of the cables going into the standard horizon plotter.
Thank you!
RE: How to existing/old nmea0183 systems? - SCarns - 2021-06-06
What's on the other end of those connector cables? Most of those old MFDs came with a connector on one end and bare wire on the other. You should be able to install a terminal strip and connect everything together without cutting anything. Then you have a good place to tie in your RPi serial connector.
RE: How to existing/old nmea0183 systems? - seva - 2021-06-06
The gps is on the other side of the white one.
The B&G network gear is just all connector to connector, except for the autopilot. But that's way in the back. As far as I can tell, would be nice to be able to plug into them. Also one of them might be a bit shady, so having replacements would be nice.
I will do some more cable tracing however. See if I can find some more bare wire bits
Thanks.
RE: How to existing/old nmea0183 systems? - SCarns - 2021-06-06
Even if you end up having to cut one of them, you'll need a manual or schematic of which wires are which for NMEA0183 TX+/- and RX +/-.
RE: How to existing/old nmea0183 systems? - Techstyle - 2021-06-07
They look similar to the first generation Seatalk 1 connectors, last year I ordered some and matched the ST1 connectors to the ones in the link below:
https://www.mouser.com/new/switchcraft/conxall-con-x-connectors/
I have the part number at Home for the 3 pin ST1 version, but you would need an 8 socket version