Arduino Nano Every not supported? - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: Pypilot (https://forum.openmarine.net/forumdisplay.php?fid=17) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=18) +--- Thread: Arduino Nano Every not supported? (/showthread.php?tid=3592) |
Arduino Nano Every not supported? - collie04 - 2021-08-19 Hello everyone, I recently purchased 3 of the new "Arduino Nano Every" boards to use as my motor controller, but I cannot upload the sketch using the standard Arduino IDE. It returns these two errors.... 1. "error -- AVR processor does not provide bootloader support" 2. "error -- cannot find SPM enable bit definition" Does anyone know..... 1. If this is because the new Nano Every boards are not supported? 2. If I tried to upload the sketches from Rasperry PI without the Arduino IDE, would I still encounter this same problem?(unfortunately I dont have my rasspberry with me to test it right now) Thanks in advance to anyone who can help! RE: Arduino Nano Every not supported? - seandepagnier - 2021-08-19 No bootloader support? Do you have a link to the product you are trying to use? Why not the standard arduino nano? RE: Arduino Nano Every not supported? - An7oine - 2023-08-16 Hello ! It's been some time I know but I have the exact same problem, so maybe one of you has found the answer and could help me. I bought the nano every because it is said that it is pin equivalent subtiture, no re-wiring needed, more powerful bla bla bla... The original was out of stock at the moment. I searched the whole day without success, but apparently the nano every doesn't have bootloader ? Btw, the link to the product : https://store.arduino.cc/products/arduino-nano-every Thanks in advance for the help ! Else I'll buy the good one. RE: Arduino Nano Every not supported? - Smallboat - 2023-09-22 (2023-08-16, 09:41 PM)An7oine Wrote: Hello ! Hi, I also bought a Nano Every for my pypilot project and had the same issue. I searched and searched and eventually came across the article below. Looks like they are not exactly the same so i have ordered the Nano. Hope this helps https://forum.arduino.cc/t/nano-every-pwm-poti-fan-control/1043858/5 |