How to setup Signalk UDP IP - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: How to setup Signalk UDP IP (/showthread.php?tid=3758) |
How to setup Signalk UDP IP - Nettuno - 2021-10-30 Hi, I have a Digital Yacht AIS transmitting via UDP all NMEA2000 Data. I connected OpenCPN to it without any issue, just setup the IP and port and OpenCPN is showing all the data. I did not achieved the same with Signal K... If I select UDP there is no place for the IP, only the Port Number. If I select TCP with the AIS IP and Port there is no data on Signal K. Somebody know how to set it up? RE: How to setup Signalk UDP IP - tkurki - 2021-10-31 Select UDP and specify port, no ip. Call me in the morning if you get worse. RE: How to setup Signalk UDP IP - Nettuno - 2021-10-31 (2021-10-31, 06:46 PM)tkurki Wrote: Select UDP and specify port, no ip. Thanks tkurki, I already tried this without success... RE: How to setup Signalk UDP IP - tkurki - 2021-11-01 Is O udp connection still active? Did you restart sk server? Any errors in the server log? RE: How to setup Signalk UDP IP - Nettuno - 2021-11-01 I've checked this morning and I realised that since I added the connection on Signalk I lost the data on OpenCPN... I've deleted the config from signalK and also from OPenCPN. Then I added again the data connection on CPN and all started working again... So I kept only the connection on OpenCPN. I guess I'm doing something wrong... at the end, I'd like to have the data available on OpenCPN and also I like to publish it to a MQTT Broker I have on the net RE: How to setup Signalk UDP IP - tkurki - 2021-11-01 You can have only one UDP listener active at a time. You can add the connection in SK and connect O to SK. Or you can add it in O and then connect SK vis tcp or udp to O. Have a look at the mqtt plugin in SK. RE: How to setup Signalk UDP IP - Nettuno - 2021-11-01 Understood! I'll try when back to the boat and I'll provide feedback about the setup... regarding the mqtt plugin, I have already installed. I'll try also when have the data into SignalK Thanks! RE: How to setup Signalk UDP IP - Nettuno - 2021-11-03 Hi, I removed the UPD connection on OPenCPN, added the signalK connection on OPenCPN and Kept the UPD connection at Signal K. Now is working great! Thanks |